Welcome, Guest
Username: Password: Secret Key Remember me
  • Page:
  • 1

TOPIC:

Electric widow switch 3 years 4 months ago #1

  • jolly
  • jolly's Avatar Topic Author
  • Offline
  • Junior Member
  • Junior Member
  • Posts: 25
  • Thank you received: 1
Can anyone please give me some advice on to remove the front window switches.

Thanks in advance
Stu

Please Log in or Create an account to join the conversation.

Electric widow switch 3 years 4 months ago #2

  • darenh
  • darenh's Avatar
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 349
  • Thank you received: 154
They are on clips, if they haven’t been out before they will be tight.
Just work a trim tool under the lip and prise up, be careful not to damage the leatherette base.

This message has an attachment image.
Please log in or register to see it.

The following user(s) said Thank You: jolly

Please Log in or Create an account to join the conversation.

Last edit: by darenh.

Electric widow switch 3 years 4 months ago #3

  • jolly
  • jolly's Avatar Topic Author
  • Offline
  • Junior Member
  • Junior Member
  • Posts: 25
  • Thank you received: 1

They are on clips, if they haven’t been out before they will be tight.
Just work a trim tool under the lip and prise up, be careful not to damage the leatherette base.


That’s great thank you.

How did you remove the trim from around the pull handle please? Is that just a case of being unclipped too?

Thanks again
Stu

Please Log in or Create an account to join the conversation.

Electric widow switch 3 years 4 months ago #4

  • jolly
  • jolly's Avatar Topic Author
  • Offline
  • Junior Member
  • Junior Member
  • Posts: 25
  • Thank you received: 1
Can anyone advise me on how to remove the trim panel around the door pull lever please?

As in the pic that Darenh was kind enough to show above.

Thanks
Stu

Please Log in or Create an account to join the conversation.

  • Page:
  • 1
  • Not Allowed: to create new topic.
  • Not Allowed: to reply.
  • Not Allowed: to edit your message.
Time to create page: 0.154 seconds