TOPIC:

" i made a small loom up with spade connectors so it just plugged in the OE loom." When you say you made new loom and it just plugged in the new OE loom, where did you manage to get a male connector to plug it in to existing connector? Assuming this what you meant. I can't get the damn original off. Limited space. Wire loom with connector is too short. Not sure if you have to press the plug in to prise off. Any tips. I'm attaching photo.

It’s a while ago, but I’m sure you push the clip down then pull the plug off.

The plug has female spade connectors in it, so I used a couple of AMP spade male connectors.

Happy days if I can manage to disconnect the plug. I think I can manage the rest. Obviously the female connections are one positive one earth?

Yes pos and neg,
I used something like in the pic then heat shrink or even tape to secure.

Cheers. I'll have another go at removing the connector off the horn this week.

I finally managed to prise off the plug. I'm on my way down Halfords to see what connectors they have. It'll be great if they have a plug that will plug into the factory plug with pins then wires from that to go into horn. The factory wires have black and green wires. The black is negative black positive? Any idea which end fits the horn? Their aren't no markings on horn body.