TOPIC:

Awkward to get a clear photo, but from what i can see, it's missing wires from pins 23 & 24, +ve and -ve.

Also too add. The two wires from that plug that are in the signal wire positions, may also not reach the boot wiring.
I have connected the camera to the supposed signal wires in the boot wiring plug and ran a auxiliary 6v supply to the cameras power wires and still no image on the screen. Leading me to believe the wiring is different on this car and I'll be running my own wires from headunit to camera. Joys.

This image is hidden for guests.
Please log in or register to see it.

That’s interesting, did you have a photo of the connector at the tail gate?
Must be missing the front loom from the foot well upto the rlink

The camera will only give an image if enabled in Rlink either via developers mode or ddt4all or clip. It’s not plug and play until enabled

Either that, or the 2019 is different. Which is very interesting. As this model has sensors all round within Rlink

Can you confirm which model yours is please? This will help me do a little more research.

darenh wrote:

That’s interesting, did you have a photo of the connector at the tail gate?
Must be missing the front loom from the foot well upto the rlink

This image is hidden for guests.
Please log in or register to see it.

This image is hidden for guests.
Please log in or register to see it.

Do you have a photo of the connector in the footwell at all? I'd much rather wire into that if it was possible too.